FLANDERS: Longview, Texas
FLANDERS has more than 40,000 square feet of workspace.
Our Longview, Texas facility has more than 40,000 square feet of air-conditioned
and heated shop space located on 40 acres with an 11,500 square foot warehouse,
a 4,000 square foot utility facility, and 22,000 square feet of motor storage. FLANDERS
Electric Longview, Texas has been established to handle the needs of major industries
in its geographical region including the Pulp and Paper, Mining, Petroleum, Chemical,
and Steel industries.
Complete In-House Machine Shop
FLANDERS performs all facets of each repair project to ensure total quality
control and fastest turnaround. FLANDERS offers complete Babbitt bearing repair,
machine shop engineering, and technical support with updates on repair status. Our
Longview facility is equipped with:
- Full Voltage Testing Through 6,900 AC
- Controlled Temperature Burn-out Ovens
- Controlled Temperature 12' x 16' Bake-out Ovens
- 900 HP Dynamometer Capability
- High Potential Testing up to 25,000 Volts
- Megger Testing up to 5,000 Volts
- Thermography Testing
- Ultrasonic Testing
- CSI Real Time Vibration Analysis Equipment
- On-site Motor Service
- Horizontal and Vertical Boring Mills up to Travel (L)80"
(W)70" (H)65"
- Balancing up to 30,000 pounds
- Vaccum-Pressure-Impregnation (VPI), Epoxy and Polyester
- Epoxy Varnish Dip Tank
- 58" Vertical Lathe
- One 30-Ton Bridge Crane
- One 20-Ton Bridge Crane
- One 10-Ton Bridge Crane
Machinists mic the outside diameter of a 6,000-hp rotor.
|
Performing core loss test on a large AC stator.
|
Motor Rewinding
Initial testing and inspection determine whether a motor should be replaced or repaired.
When repair is required, the rewinding process begins. After stripping, cleaning
and further testing, replacement coils are manufactured and installed. FLANDERS
uses Class H rating insulation on coils when only Class F is required to provide
maximum longevity in the most severe applications.
Armatures are stripped with care to ensure the highest quality.
|
FLANDERS removes and rebuilds motor coils with very little downtime for the consumer.
|
Field coils inspected on a DC motor.
|
A service technician winds a DC armature.
|
Field Services
Specializing in on-site services in a variety of industries, FLANDERS field engineers
and service technicians provide technical support and repair services, including:
- Installation and Start-up
- Predictive Maintenance
- Preventive Maintenance
- Laser Alignment and Vibration Testing
- Troubleshooting and Repair
- On-site Reconditioning and Dry Ice Blasting
- Thermography Testing
- Megger Testing up to 5,000 Volts
- MCE Testing
With an entire fleet of trucks, FLANDERS Longview, Texas is capable of
transporting even the largest job to our shop from any customer location.
More Photos
58" Vertical Lathe.
|
The air gap on a 1,250-hp motor is adjusted.
|
All armatures are thoroughly tested to assure quality.
|
An infrared camera is used to determine hot areas on rotors and stators.
|
Horizontal millwork includes repairing stator registers and facing stators.
Back to Top | Contact
|
